Braun Silk-épil 9 Flex stops after two seconds? Check the head, not the battery

3 min readupdated
The opened Silk-épil 9 Flex with its circuit board showing. A red circle marks the two white tabs in the head socket, next to the shower icon, with the label “These two tabs pick speed I or II”.

Problem

The Braun Silk-épil 9 Flex would start, run for a second or two and switch itself off. Every single time. It looked like a dead battery, and it very nearly ended up in the bin.

Solution

  1. Take the head off and look at the head socket. Next to the little shower icon there are two white spring tabs.
  2. A head presses one of them when it clicks on, and that tells the electronics which speed to run: I or II.
  3. Press one of them yourself and switch the epilator on. If it runs normally, the body is fine and the head is the problem.
  4. Try the other heads. Mine all worked, except one.

Technical details & puzzles

The opened body with the orange Li-ion cell. A label reads “4.01 V idle → 3.98 V running”.

Everything pointed somewhere else. The Li-ion cell read 4.01 V and only dropped to 3.98 V with the motor running, which is a perfectly healthy battery. Three AA cells at 3.8 V did not start it at all. It turns out that once the battery is disconnected, the epilator plays dead until you plug the charger in to wake it up. On the motor I measured about 3 V on speed I and 2.2 V on speed II. Lower on the faster speed made no sense, and it was the first hint that the electronics was choosing to stop, not running out of juice. No corrosion on the board either.

Result

The body, battery and motor are fine. The faulty head had one of its clips cracked, so it sat a bit loose and did not push the tabs down properly.

The Silk-épil 9 Flex in hand, with the head on and the neck wrapped in orange electrical tape.

The temporary fix is the most honest piece of engineering in the house: electrical tape. Wrapped around the neck, it holds the head tight and the epilator runs as it should. The only catch is that the other heads are off the menu until the tape comes off. Whether I glue the clip or buy a new head, I have not decided yet.

Story

My wife asked me to have a look at her epilator. Her theory: the battery was dead, because after a few hours of charging something was clearly off, the LED was blinking and it kept switching itself off. She was half right. At first the LED was indeed yellow, so I gave it another few hours on the charger. After that the LED looked happy. The epilator still died after two seconds.

So I opened it up and went through it with Claude. It started with the obvious suspects: a tired battery, then undervoltage cut-off, overcurrent from a jammed gearbox, a worn motor and finally the microcontroller resetting itself. Each theory sounded great and each measurement killed it. In the end, while staring at the opened body, I noticed the two tabs under the shower icon and pressed one of them. Two seconds turned into normal running. Only then did I take a closer look at the head and find the cracked clip.

The simplest answer was sitting in the socket the whole time. Leaving this here for the next person about to throw theirs away.